Magneti Marelli distributor cap for all Lancia Delta integrale models apart from Evo 2.

Distributor pick up for Lancia Delta integrale 8v, 16v & Evo 1. Made in Italy.

For non-cat 8v. Not available. It is possible to retrofit the 16v coil to an 8v application by modifying the terminals. See part No.: 7746227

APS 02/03 black map sensor for Lancia Delta integrale 8v, 16v, Evolution 1 & Evo 2. Reproduction map sensor from Italy, made to original spec.

Relay for fuel pump and engine ECU for integrale 8v, 16v and Evo 1.

Also headlights, heater fan, horn, cooling fan, rear screen, rear wiper, A/C.

Rotor arm for all Lancia Delta integrale 8v, 16v and Evo 1. OEM supplier, made in Italy. Fits all models with distributor caps.

O-ring seal for the distributor to the cylinder head for Lancia Delta integrale 8v, 16v and Evo 1.

The blue rotary oil seal on the distributor body shaft for Lancia Delta integrale 8v, 16v & Evo 1.

Oil pressure sender for 8v non-Kat integrale only.

Expansion bottle water level sender. Fits all models with check control.

The air temperature sensor in the inlet manifold. Originally brown topped.

For all Lancia Delta integrale 8v,16v, Evolution 1 and Evo 2 models.

Genuine Magneti Marelli crankshaft TDC position sensor for Lancia Delta integrale 8v, 16v, Evo 1 & Evolution 2. Also known as crankshaft position sensor, TDC sensor, timing sensor, top dead centre sensor. New, factory-supplied part.

Original Magnet Marelli "Blue" water temperature sensor for Weber Marelli IAW engine management.

Fits Lancia Delta integrale 8v, 16v, Evo 1 & Evolution 2.

Oil Pressure Switch Integrale 8V > VET 402807. The type with the single spade connector. Fits to the oil filter housing block.

Oil pressure switch for Lancia Delta integrale 8v, 8v Kat and 16v. Not for Evolution models. Made in Italy.

Throttle Position Sensor (Potentiometer) for Lancia Delta integrale 8v, 16v, Evolution 1 and Evo 2.

Fully reconditioned original starter motor for 8v (no Cat) integrale.

Oil temperature sender unit for all models (Lancia Delta integrale 8v, 16v, Evo and Evo 2). OEM specification, made in Italy.

New alternator for all integrale models.

Idle control valve for Lancia Delta integrale 8v, 16v, Evo 1 & Evo 2.

Ignition switch for Lancia Delta integrale 8v, 16v, Evo and Evo 2.

Ignition coil and amplifier assembly for 8v Kat, 16v and the Evo 16v variant with distributor. Also for 8v (after the changing of a plug on the car's loom).

Lambda sensor for Lancia Delta integrale 8v Kat & Evo 2 models.

Original equipment Magneti Marelli HT leads set (5) for Lancia Delta integrale 8v and Evo 8v Kat models. (Includes coil lead).

The correct standard triple electrode spark plug for Lancia Delta integrale 8v, 16v, Evolution 1 and Evo 2 models. NGK branded very high quality original equipment spark plugs.

Sold individually.

x4 needed.

Magneti Marelli distributor assembly complete for Lancia Delta integrale 8v, 16v & Evo 1. NO LONGER AVAILABLE

Magnecor uprated ignition leads for 8v integrale (including 8v Evo). Includes coil lead. Blue 8mm cable.

Replacement ignition amplifier for all models. 1 per coil.

2 needed for Evo 2 fitted to aluminium heat sink. Sold individually.